Shop verification card
Hi-Lok
LISI · Pin and collar · HL10 / HL18 protruding shear head · HL11 / HL19 100° flush shear head · typical collars HL70, HL79, HL82, HL94, HL97
speclok.com
11/16/2026
Install sequence
1. Pin inserted
2. Collar threaded on
3. Driver engaged
4. Torqued off
5. Installed
Traced from Hi-Shear Hi-Lok and Hi-Lok/Hi-Tigue Installation Instructions, p.10, I.1. Not to scale.
Before you install
- Diameters offered: 5/32, 3/16, 1/4, 5/16, 3/8"
- Tool: Hex key (holds the pin) and collar driver (Howmet Hi-Lok system)
- Standard shop tooling.
- Training: Not stated in the cited documents.
- Lead-time risk: Low
Installed preload
Preload force is not published. What is published is the collar wrenching-hex torque-off range per size, the mechanism that sets preload: e.g. HL86 CRES tension collar -6: 40-50, -8: 110-130, -10: 200-250 (Hi-Shear collar standard sheets, Hi-Lok Product Specification 345). Howmet: the design "cannot be over-torqued... eliminates the need for torque inspection."
Removal
Published: Hi-Shear Hi-Lok Installation Instructions, K. Removal of Installed Fastener. NOTE: Initial loosening of the -8 and larger Hi-Lok collars with the HLH128 Removal Tool is recommended. Steps: speclok.com/tooling/hi-lok#removal
Accept / reject after install
- The collar wrenching hex must have sheared off cleanly; the remaining collar portion is the installed configuration shown on the standard sheets.
- Pin protrusion and collar-seating gap limits are not published at the manufacturer level; quantitative limits live in the airframer's process spec or SRM.
Check gauges
- None published by the manufacturer; torque inspection is designed out by the shear-off hex.
Sources: HL86 collar sheet · HL18 pin drawing · Howmet Hi-Lok system. Acceptance limits belong to the controlling spec: verify against your program's process documentation before use on hardware.
Sources
Reference only: the controlling drawing, its process spec and the manufacturer's installation instructions govern. How to use these answers