Shop verification card
Cherry Maxibolt
Cherry · Blind bolt · CR7310 / CR7311 alloy steel (MS90353 / MS90354) · CR7620 / CR7621 A-286 (MS21140 / MS21141) · e.g. CR7310S-06-04 = MS90353S0604
speclok.com
11/16/2026
Install sequence
1. Spindle pulled
2. Blind head forms
3. Pulling portion removed
Traced from Cherry CA-1009 (MAXIBOLT), p.2, Installation sequence with shifting washer. Not to scale.
Before you install
- Diameters offered: 1/8, 5/32, 3/16, 1/4, 5/16"
- Tool: Cherry Maxibolt installation tooling and pulling heads (CA-1009 "Installation Tooling and Pulling Heads")
- Proprietary system required.
- Training: Not stated in the cited documents.
- Lead-time risk: Medium
Installed preload
- Alloy steel (MS90353/54), min tensile preload: 5/32": 135 lb · 3/16": 210 lb · 1/4": 365 lb · 5/16": 520 lb (MIL-F-81177E Table IV)
- A-286 CRES (MS21140/41), min tensile preload: 5/32": 115 lb · 3/16": 169 lb · 1/4": 290 lb · 5/16": 417 lb (MIL-F-8975B Table III)
- Titanium (CR777x), min tensile preload: -04: 60 lb · -05: 180 lb · -06: 280 lb · -08: 420 lb · -10: 620 lb (Cherry PS-CMB-7000 Table IV)
Minimum installed-preload acceptance values from qualification testing (per MIL-STD/NASM-1312), roughly 10% of minimum tensile strength; not typical clamp-up.
Gauge kit (published part numbers)
| Gauge | Sizes | Checks / limits | Source |
|---|---|---|---|
| 269B12 | all | 269B12 Grip Gage | Cherry CA-1039 (MAXIBOLT process manual), p.11, Fastener Selection, 269B12 Gage |
Removal
Published: Cherry CA-1039 (MAXIBOLT process manual), Maxibolt Removal. CAUTION: DO NOT drill completely through the head or the sleeve to remove a blind bolt as this will enlarge the hole. Steps: speclok.com/tooling/cherry-maxibolt#removal
Accept / reject after install
- Stem position per diameter: alloy steel max protrusion -05: .020" to -10: .038", fracture surface may not recede below top of head; CRES/Ti protrusion and recession .010"-.020" by dash (CA-1039).
- Collar position: flush or below top of sleeve head, max values per dash.
- Head seating checked with a .002" feeler gage: a .002" gap is permissible over up to 40% of head circumference and must not reach the shank (CA-1039).
- Blind head minimum diameter per dash per the visual inspection tabulation.
Check gauges
- 269B12 Maxibolt grip gage.
- .002" feeler gage for head seating.
Sources: CA-1039 process manual · MIL-F-81177E · MIL-F-8975B · PS-CMB-7000. Acceptance limits belong to the controlling spec: verify against your program's process documentation before use on hardware.
Sources
Reference only: the controlling drawing, its process spec and the manufacturer's installation instructions govern. How to use these answers