Shop verification card
Cherry E-Z Buck
Cherry · Solid rivet · CSR902/903/904 · e.g. CSR902B-6E-5
speclok.com
11/16/2026
Install sequence
1. Inserted
2. Buck or squeeze
3. Upset formed
Traced from Cherry CA-1032 (E-Z Buck), p.9-11, CSR904D drawing; Inspection; Rivet Grip Selection. Not to scale.
Before you install
- Diameters offered: 3/32, 1/8, 5/32, 3/16"
- Tool: Rivet gun and bucking bar, or squeeze (CA-1032 "typical squeeze load" guidelines)
- Standard shop tooling.
- Training: Not stated in the cited documents.
- Lead-time risk: Medium
Installed preload
Solid squeezed rivet; installed preload is not a published concept. CA-1032 gives "typical squeeze load" installation guidelines (-3: 1200 lb to -6: 5000 lb), which are installation force, not residual clamp.
Removal
No published removal procedure found; follow the manufacturer's instructions. Steps: speclok.com/tooling/cherry-ez-buck#removal
Accept / reject after install
- Driven-tail upset: minimum diameter 1.3D (-3: .122" to -6: .243"); minimum height 0.3D (.028" to .056") (CA-1032).
- Pre-drive grip check: backside protrusion 0.8D min / 1.5D max before driving.
Check gauges
- No inspection gauges published; upset dimensions are measured directly.
Sources: CA-1032 catalog. Acceptance limits belong to the controlling spec: verify against your program's process documentation before use on hardware.
Sources
Reference only: the controlling drawing, its process spec and the manufacturer's installation instructions govern. How to use these answers